What Does a Gas Detection System Cost? A Price Guide for Ireland

Guide by Vistec Gas Detection. Last updated November 2026.

What does gas detection cost? For a portable detector, from a few hundred euro. For a fixed system, it depends on how many points you need to monitor and how they are wired, so the honest answer is a site survey and a quote. This guide gives indicative price ranges for each part of a gas detection setup, based on published list prices in November 2026, so you can budget before you ask us for a firm figure.

How we have put these figures together

The ranges below come from published list prices at UK and Irish safety equipment retailers in November 2026, converted to euro at roughly 1.17 euro to the pound and rounded. They are indicative, exclude VAT, and exclude installation unless stated. Prices move with exchange rates, sensor types and quantities, so treat them as a starting point rather than a quotation.

Vistec prices every job on the specification: the gases to detect, the number of sensor points, the panel, the cabling and containment, and what the system has to control. Call 01 289 7720 or email info@vistec.ie with a drawing or a description of the space and we will quote it.

Portable gas detectors: 250 to 700 euro per unit

A single-gas personal monitor such as the Crowcon Gasman lists at roughly 250 to 450 euro depending on the sensor. Common sensors (oxygen, carbon monoxide, hydrogen sulphide) sit at the lower end; carbon dioxide and nitrogen dioxide versions cost more.

A 4-gas monitor for confined space entry, such as the Honeywell BW GasAlertMicroClip XL (flammable gas, oxygen, carbon monoxide and hydrogen sulphide), lists at roughly 450 to 700 euro. Multi-gas instruments with a pump, a PID sensor for volatile organic compounds, or ATEX certification for hazardous areas cost more again. A docking station that bump tests and charges several units automatically is a separate purchase that pays for itself where a crew uses monitors every day.

See our portable gas detectors and confined space gas monitors pages for the models we supply.

Bump test and calibration gas: 130 to 170 euro per cylinder

A 34 litre cylinder of single-gas or 4-gas mix lists at roughly 130 to 170 euro. One cylinder covers a long run of daily bump tests, and a regulator (bought once) is extra. We stock test gases and regulators matched to the detectors we sell and service.

Gas detector calibration: from about 60 euro per portable unit

Send-in calibration services in the UK advertise from roughly 50 to 65 pounds (around 60 to 75 euro) per single or multi-gas portable detector, more for PID and specialist instruments. On-site calibration is priced per visit plus per detector, which works out cheaper per unit once an engineer is calibrating a fleet of portables or a fixed system with several sensor heads in one trip.

Every calibration we carry out uses certified test gas and ends with a calibration certificate for your records. Our gas detector calibration page explains what the visit involves, and our guide on how often to calibrate gas detectors covers intervals.

Fixed gas detectors: 250 to 2,000 euro per sensor head

A standard fixed detector head for flammable gas, carbon monoxide or oxygen depletion lists at roughly 250 to 500 euro. Intelligent transmitters with a local display, multiple outputs and ATEX or IECEx approval for hazardous areas list at roughly 1,000 to 2,000 euro each.

On top of the heads you need a control panel sized for the number of sensor channels, power supply and battery back-up, sounders and beacons, and in most installations a gas solenoid valve so the panel can shut the supply. Our gas detection control panels page compares the panels we supply from GDS, Medem, Coster, Flamefast and Duomo. Installation cost is driven mainly by cable runs and containment, so a plant room with the panel beside the sensors is far cheaper to wire than a car park with sensors spread over several levels.

Gas interlock systems: panel from about 120 euro, installed cost depends on the kitchen

A commercial kitchen gas interlock panel lists at roughly 120 to 250 euro, and a gas solenoid valve in the common small commercial sizes at roughly 80 to 130 euro. Larger valves, current sensors for the extract and supply fans, emergency stop buttons and a gas detector add to the parts list.

The installed price depends on where the fans, the gas meter and the appliances are relative to each other, because every one of those has to be wired back to the panel. The gas pipework side of the job must be done by a Registered Gas Installer. Our gas interlock systems page describes the components and the standards, and our I.S. 820 guide covers the rules for non-domestic gas installations.

Maintenance contracts: priced per visit and per sensor

A maintenance contract is priced on the number of detectors, the number of service visits a year (usually one or two) and the travel involved. It includes scheduled calibration and functional testing, a report and certificate after each visit, and priority call-out, with 24-hour call-out available. For most sites it costs less than paying for the same visits one at a time, and it removes the risk of a missed calibration. See gas detection maintenance contracts.

What makes a quote higher or lower

Send us a drawing or photos of the space, the gases you are concerned about and the number of rooms or levels, and we will come back with a priced specification.

Common questions

How much does a 4-gas monitor cost?

A 4-gas personal monitor such as the Honeywell BW GasAlertMicroClip XL lists at roughly 450 to 700 euro excluding VAT in late 2026. Pumped, PID and ATEX-certified multi-gas instruments cost more.

How much does gas detector calibration cost?

Send-in calibration of a portable detector is advertised from roughly 60 to 75 euro per unit in the UK. On-site calibration is priced per visit plus per detector and is usually the cheaper route for a fleet of portables or a fixed system. Vistec quotes on the number of instruments and the site.

How much does a fixed gas detection system cost?

A standard fixed detector head lists at roughly 250 to 500 euro, and intelligent or ATEX-certified transmitters at 1,000 to 2,000 euro each, before the control panel, valve, sounders, cabling and installation. The number of sensor points and the cable runs decide the installed price, so a survey and quote is the only reliable figure.

How much does a gas interlock system cost?

The interlock panel itself lists at roughly 120 to 250 euro and a small commercial gas solenoid valve at 80 to 130 euro. The installed cost depends on wiring the fans, the valve and any detector back to the panel, and the gas pipework must be done by a Registered Gas Installer.

Does Vistec publish a price list?

No, because every fixed system is priced on its specification. We do give firm quotes quickly from a drawing or a site visit, and we can supply portable detectors and test gas at list price. Call 01 289 7720 or email info@vistec.ie.

Get a priced specification

Tell us the space, the gases and the number of points, and we will quote it. Call 01 289 7720 or email info@vistec.ie.